Search results

So i ordered some injectors off ebay for my 5.2.. when i pulled one of the old ones out i put the old and new side by side just to be sure.. well i noticed the new ones were shorter, but other than that almost identical, well except for the fact that they say ford on them LOL. So i did a...

I have a 94 grand cherokee larado, 5.2 awd automatic. today i had some problems with it starting, it would start.. but ran rough as if it was only on 6 cylinders. After a few min. it was fine. I am in FLorida and it was a very hot humid day. Also, when i give it gas or accelerate my a/c...

4 Jeep Cherokee Wrangler wheel rim OEM 1997-2001 15X7 | eBay

Im looking for a power chip on ebay, but cant seem to find one for jeep. But see tons of them for the dodge ram 5.2, Does the jeep share the same computer? Im only looking to spend $30-$50, any suggestions would be helpful

This is just out of curiosity.. i have a 94 grand cherokee awd v8, im just wondering.. can i swap a newer more fuel efficient v8? Id like to keep my transmission and rest of drive trian.

Ok.. I needed new front pads. Not a big deal,. Well got the new pads in and discovered my bleeder valves were stuck to point that i stripped both of them, so i just decided to get new calipers. Put everything back together, Bleed all 4 lines. No air, new fluid coming from each line, BUT NO...

just bought a 94 laredo 4x4 with 5.2 and auto trans, everything seems to work, but it shakes just a bit at idol, then calms when taking off till about 45mph. gets really bad when it hits overdrive! especially when i give it gas. Once its past 60mph it calms down. Im thinking maybe a motor...

can i put a wrangler or cj body on my cherokee? I love my cherokee, but i gotta say., having no top is soooooooo tempting!!!!

my factory air box is warped, wont fit a filter anymore, i just ripped it out. Now i have vac lines hanging and no filter lol. It runs like crap at idle till warm. Has some power loss. I want to use PVC to make a new intake with a cone filter. How and where do i run the lines that were on the...

where is it? how do i test it? i know the compressor and clutch are both good, i hard wired it. So now what

i just changed the fluid in the rear end and noticed the numbers on the cover, so i looked it up.. all i really know is that its a dana 35, i wish i had looked inside more before putting back together! anyway...... how do i know if its a LSD rear end and do any of the number indicate what gears...

ok , so i have grown up with hot rods, bikes and car audio.. 4x4s have always been an interest of mine. I finally got a jeep... but i keep getting stuck! well not completely stuck, seems i can rock my way out but it takes some time. So i need a lesson in driving through soft sand!! if anyone...

its on right side of coolant resivor.. and it leaks :( i cant find it in the repair book. also where does the blue vac line in the pic go?

i just got my jeep.. first one! very excited.. but needs work!! I want to redo ALL the vac lines with new ones, but i think some of it has been messed with and i dont wana screw it up (its a mess!) lol. Any ideas on how to redo it all? and can i get rid of the stock intake and bypass some...