Search results

I'm in northeast Ohio, so smog is not a issue.

I had a feeling that would be the case. This is why i love this place, always someone with a answer. Thanks for the input. In getting the jeep for free so I might give it a try. I'm ok with electrical, but my buddy is a genius so I'm hoping we can figure it out. Would be kinda cool to have the...

The zj has a 4.0 in her.

Going to be picking up a 97 zj that has the awd and is auto. Just wondering if I could take the manual trans and np231 out of my 94 xj and swap it in. The zj I'm getting for free. It's a impound where I work and the boss wants it gone. Just wondering if this is possible or not.

I'm getting a good deal......free... On a mint fully loaded 97 grand Cherokee. I have a 94 xj that has a manual with the 231 transfer case. I wand to swap the trans and transfer case to the zj. Has anyone done this, or it it even possible? Any inputs would be a great help. Thanks in advance.

I run a 8000 and have never had a problem. But I also have a snatch block just in case thinks get serious.

I was at my bosses house. There is all sorts of equipment. It's a lot easier than winching.

Got a little to crazy last night. Rolled her back over with a 135 kobelco and kept wheeling.

The regulator is in the computer. I had a similar problem but my headlights and radio blew up. Turned out my positive and negative battery leads were shot and most of the insulation was gone. they shorted out taking the alternator with it.

I did mine on a 90 xj. Pain in the ass. Just get a good air hammer and it will bust the nut right out of there. Use a piece of tie wire to fish new bolts through the top. Kind of hard to tighten but it gets the job done.

How big is the difference in tire sizes?

That looks like a evap canister.

Just got done adding a 2" budget boost to the 4" skyjacker lift already on it, and some new bfg mud terrains. Had to test her out.

When in doubt just add it. It's like 7 bucks at advanced. It won't hurt anything if you don't have limited slip and if you do then you need it anyways. Up front don't cone with limited slip so just add regular gear oil unless you want to spend all that money on synthetic

To my know how. And don't quote me but you can switch hubs, then will be able to put lockouts on done axles. But I know you can't just put them on a stocker.

If you are good with a welder you can run a small bead all the way around the inside of the race and when it cools is usually almost falls out. I used that trick a lot when I used to rebuild portal axles on tractors. A lot of bearings in there. Just make sure you cover everything that you don't...

I have a 90 xj and just recently put a high output alternator. 105 amp I think. I got it from napa, it was better than stock and not much more cost. My problem started yesterday when I picked up a optima red top because my old battery was getting old and after running the winch a time or two (on...

Little beat up but running strong 90 xj

Sounds like a u joint as mentioned before. If the noise is as bad as you say it should be pretty obvious what joint it's coming from. I doubt it's and ball joints but check them wile your at it.

At my work we use hurculiner on our dump trucks and equipment where the paint would always get beat up and it has held up amazing. Every year we touch it up because it fades but as far as protection you can't beat the stuff for the price.