Search results

Found out my problem! I guess Chrysler started throwing stuff together in the 90's! My original throw out bearing is the same as a 90 wagoner L6, and the throwout I have now is for a 90 wrangler L4 and I need the wagoner throw out bearing! Could Chrysler make things anymore difficult! Especially...

Not that I know of! I am.still learning on this jeep, is there a proper why to burp the air out! I been running it and its been good it still hits 260 and I noticed when that happens it starts to suck all my anti freeze out of my backup resevor

South Texas

Well I. Changed the clutch and throw out bearing and pressure plate, and when I bleed the throw out, it works great for a little bit but when I come to a complete stop my 1st and reverse starts to grind, as if the clutch is not engaging! I changed the hose from the m/c to throw out and and I...

Got a set of 4 American made steel rims that fit a CJ bolt pattern! They are 10 inch rims, ask $150 for them.

I made sure the pump is not spinning backwards, its does good on the open road and city limits, but when I kick in the the four wheel drive that's when it starts to over heat

Just Replaced. My water pump and.now its running to hot, so I took the thermostat out! And I was also wondering if my belt from the power steering to my pump was to tight could that effect it from cooling down as well.

And those will bolt to a YJ a small bolt pattern.to a big?

Can anyone give me some advice on a easy way to drop. My transmission without using a bike lift because I need to replace my burnt clutch

I got.a 90 wrangler on stock rims, but bought a set of old CJ rims and I need the conversion spacer! A set of 4

Yes sir its a old engine when I change my oil I throw a quart of Lucas In it and stop but after a week the noise comes back.

Was wondering if I could take the cover of and tighten the rockers down because its tapping or.do I need to replace them?