Search results

So finally adjusted my steering for the last time, turns almost as much as stock. Tie rod rubs just a touch on the new replacement bolt for the track bar from Rustys. Feels great, firm. Still think offset tie rods would be better. With that said I give it 5 and 3/4 stars.....

After

before

. Before

So I got hold of Rustys, basically bad instructions with the kit. Per the instructions and the Photo. The drag link tie rod end is to mount with the nut pointed down. Rusty said to rotate it about 10°. My clearances lot better, tried to upload photo but my phones not cooperating.

i just installed Rustys offroad cross over steering on my xj , cant and wont turn as sharp. hits the axle on pass. side clears diff and every thing on drivers side, only fix i see is offset tierod ends to push it out. have not gotten hold them yet. i work 3rd and hard to get hold of them with my...

Plasty dip works well

Yes... Pump till your leg goes out then pump with other leg... True story, you have to pump them forever.

I have a 93 yj and have broken 2 power steering reservoirs off myself,at the hose inlet..its J.B. welded now lol. trying to find a aftermarket aluminum one..

Sounds like a bad relay..

Autozone has them, most parts store should..

so far so good went for about 10 mile drive mostly high speed and was fine came home and no codes. can't believe that a speed sensor make it run like that? but tonight is the test going to work up the hills and for 45 min.s

ok so driving today and was a lot better only , when @ 45+ at steady speed does it run a tad ruff. put speed sensor in tonight haven't test drove yet...wish me luck..

Had to take it for a drive and was a lot better. Going to get speed sensor tomorrow morning.

so driving my 45 min drive to work @ 60 mph. she starts to sputter, like cut out for a sec. then BooM! she goes out the air cleaner...then is fine? ok strange. 12 hrs. later forgot this happened till sputter sputter...... pop pop boom boom BOOM! down to 5 mph is all it would do. pulled over and...

replaced broke degree shim and torqued to 65lbs per Rough Country..? that dont feel right... boy do I need some tires.

Don't forget" lots of love and even more$$$"

I believe 12 is that it has started to read codes. To clear codes unhook battery for a few mins and it should clear codes and relearn. May take a few start ups to fully learn I have a 95 2.5 5 speed with air lol had same code 33 come up and my air works fine?

Thanks just wanted to make sure..

I thought I read it was best to remove the front track bar, so when I did my lift I did. It's been about 8 months and now I have a Pop sound turning tight corners, also noticed front axle moves left and right a bit before wheels turn left or right? Is this ok? Drives fine on highway... Or am I...