Search results

5.2 has a pcv and that side goes from the passenger valve cover gasket and plugs into the intake. By disconnecting the hose from the valve the car runs but is a little rough but you can drive it forward and in reverse, if you connect it then it dies. I think I will get the new plenum fix...

Got that, but what would cause the blockage? If you leave the pvc line unconnected, the car will run with issues but MUCH better then with the pvc connected. When I did connect the pvc it rattled which it should but it stalled out. I don't know what else to look for? Would the egr also cause an...

Don't know about fuel pressure, but if I remove the pcv hose and leave it connected to the throttle body, I can drive, back up etc. When I connect the pcv valve to the hose it dies. Would the fuel pump cause an issue? The gas tank when you went down to fumes would have pressure when you released...

GO ARMY.. :) The passenger side (no pcv) has great vacuum, the drivers side has the breather valve pushing out air. I assume that that is correct. I sprayed starting fluid all along the intake and the hoses and no change. Anything else? Thanks for the reply.

Had the transmission replaced and now around 20 mph it clucks to 1st gear. Any help on this???? Other then that the trans is GREAT...

Since replacing the IAC, no codes and yes I have disconnected the battery for all instances.

Have replaced the IAC, MAP, and TPS and still the same thing. The throttle body was taken off and completely cleaned and it will not idle. If I remove the PCV valve and let the intake breath by itself it runs like a champ with a little miss. Any help here? Would this be a plenum issue? Thank you...