bar

Hello !!! New cj owner and new to forum. My cj had a 350 swap and now has shift box on floor. A B&M race shifter was put in and the box impedes 4WD shifting. Can I just replace shift bar or do I need to replace entire unit ? Lokar shifters ? Thank you in advance !!!! Sincerely- Cutter

Hey everyone first post here. I have a 2015 Jeep Wrangler JK Unlimited that I am doing upgrades on. I am currently working on the fenders and I was wondering if anyone knows how to remove the fender support bar? I put an image on here so you know what I am talking about. I think it looks ugly...

I rebuilding my 1999 Wrangler, Installed 2 new coil springs after one brook in the accident. I have installed new upper and lower control arms however the track bar is 2" from its frame mount. Any Ideas on where the back axle aligns with the frame. I am currently only off 3/8" from being...

Hello, I am new member from NM. I have bought a wonderful 99 Jeep Wrangler 5 months ago with low mileage, putting into the garage for safe keeping out of the sun. To say the least I have not put that many miles on the Jeep before I rolled it on our first Snow storm of the season. I did not...

My front drivers side frame broke from the steering gear box extending to the shock tower. I found a new replacement frame section that extends that far and have it ordered, but it does not come with a replacement track bar mount. I called the company and they said to remove the last one and...

I have a right hand drive 1996 Jeep Cherokee that needs the front track bar frame rail BRACKET replaced....... can not find it because it is not made anymore nor is it in any junkyards in the U.S........so my question is how do I change the part to something different without doing a lift kit ...

WURTON is a premier manufacturer of high-performance LED lighting products intended for the demands of the Automotive, Off Road & Industrial markets. Our products are engineered using the most advanced manufacturing technology available today, resulting in unparalleled quality, and extreme...

I have a stock sway bar and endlinks and wanted to put pins in like this. Jeep Homemade Swaybar Disconnects My question is with a lift can i do this with my stock endlinks. I am worried that if i disconnect the links that they are under pressure cause of the lift. If i disconnect them will i...

Hey im new to the forums and i dont actually have a jeep but a week ago my friend came to me wanting me to build him a soundbar..i accepted the task and began..It has two 6.5 holes ready to house a pair of fosgate T162C's and two 5.25 holes for cheapo pair of sony xpoldes from walmart and the...