rod

So I was replacing the wheel hub on my 03 liberty when I accidently stripped the threads trying to remove the axle nut, leading me to have replace the entire passenger side axle. The new axle comes and I go to install it but it will not seat all the way in. The axle and the axle rod are two...

Hello all! I just picked up an 08 Liberty 3.7 auto 4x4 with 80k and noticed it has a faint deep knock after it's warmed up. The knock is only there when in gear at idle. You can feather the gas and hear it but it's gone upon acceleration. I'm assuming it has a bad rod bearing, I'm just wondering...

Hi I was getting a lot of codes and my Jeep went into Limp mode. I cross referenced the codes with possible problems. It’s either at the Transmission Control module (TCM) is bad, the solenoid pack & sensors are bad, I need a new transmission or the fluid/filter are dirty. I decided to change...

Hi folks. I'd be a new Jeep owner if I was to do this, here's my question: Is it possible to install a 4.0 inline 6 (that is currently in a 1995 Cherokee Laredo - that engine itself was a fully rebuilt one installed 3 years ago) into a 2000 Cherokee Laredo that currently has a V8 in it - with...