What Terry found on Ebay seems to be a good deal for today's prices... The ones I used were for one of those tall metal two door office cabinets. I think they came from the local locksmith shop and were like 12 or 15 dollars each (but that was like more than 20 years ago) . Bring in an old handle so they can match it up. Remember that you need to reuse your original square shaft. Press out the little pin holding the new shaft, install your original shaft, and press the pin back in. You could always tell when the handles were worn - they would start to sag (not stay horizontal) and get wiggly. Then, one day, you'd end up breaking the handle off in your hand. Or, in the woods, they get snagged on brush and shear off :roll: . What fails is the area around the square shaft where the little pin is pressed into the potmetal. The rest of the latch assy is actually pretty good quality. Best of luck - John