What did you do to your Jeep today?

[mikeswillys]

Looks like a fun day!


Sent from my iPhone using Jeepz.com mobile app

[superj]

finally put the skid plate drop kit on. it almost completely got rid of the vibration so maybe a washer or two more and it will be completely smooth.

and learned the t-case shift level needs a drop too, or a cable replacement instead of the z linkage. i will try the bracket first and go from there. this was completely disconnected so i think when it rolled, the transmission slid sideways and linkage was knocked out of place. with the skid drop though, its not inline anymore, anyways so.. we shall see how it goes though

[superj]

Picked up a front bumper for the ol jeep. Pretty decent price and a nice drive through the coast side to get it

[mark sr]

That trolley jack looks just like mine. I bought it from Harbor Freight and Salvage over 40 yrs ago. My son who was 2 at the time removed the plate [and lost the screws] right after I bought it.

[superj]

ha ha ha, that is probably where this is from and i know its at least 25 years old because its from before my kids were born

[chae]

nothing new but the wheel steel we ordered came today!

[JPNinPA]

That trolley jack looks just like mine. I bought it from Harbor Freight and Salvage over 40 yrs ago. My son who was 2 at the time removed the plate [and lost the screws] right after I bought it.

Yep. Mine is blue


Never look down on anyone unless you are helping them up - Jesse Jackson

[superj]

Bumper is on. Took hours because the top holes we 1/8" to close so I had to get a Dremel and make them a little larger. Thannn the stupid welded nuts in the frame, closest to the grill, snapped free. So lots of fun during the install but I eventually got to this point....

And I cannot load pics again. Just says upload failed. Yeah!

Maybe tomorrow

[mikeswillys]

Did it have an aftermarket bumper already? Lucky you didn’t have to do the relocation bracket.


Sent from my iPhone using Jeepz.com mobile app

[superj]

no, it didn't. why would you need a relocation bracket for a front bumper?

[mikeswillys]

There is a vaccume pump bracket between where the winch plate bolts in. You have to cut it off on 2012 and newer I think


Sent from my iPhone using Jeepz.com mobile app

[mikeswillys]

Vacuum pump is what I was trying to spell. I only know because I recently put a front bumper on mine and it was a doozy to get a cutting tool in there. You are lucky you didn’t have to worry with it.


Sent from my iPhone using Jeepz.com mobile app

[superj]

Mine is not 2012 or newer so I am glad

[Andrew Mac]

Added some ducks I acquired at Jeep Beach 22!

[mikeswillys]

Installed my GMRS radio today. Just gotta figure out what I’m doing with the faceplate.


Sent from my iPhone using Jeepz.com mobile app