Recent content by drag0n

its gotta be the muffler bearing, that damn thing is always going out! ;)

when i open it up, it goes output shaft up? do i have to worry about holding anything in so it doesnt fall apart?

how hard is doing an sye on the stock tcase for an 89 yj? i have wanted to do it for a while, but opening tcases and transmissions scares me a bit...

best bet is to take it to autozone and have them test the battery... try this, when it is running, unhook the battery, if the jeep still runs, the alternator is good and the battery needs replacing, if it dies, the battery is good and the alternator is bad...

yours too? :D actually, she just hates the exhaust or lack thereof (headers anyone?)

i might have to weld it untill i can get up the money to buy all the rest of the hardware i need, but i will most definately go around the frame with the hammer and see if i can find any bad spots (insert prayer of choice here)... i appreciate all of the help

how about strong? im less worried about quick and easy if it compromises strength, if it is going to break under moderate (as much as i can do without several thousand dollars of rock crawling mods) stress... also, since the crack is the better part of the area around the frame, am i going to...

i have little-no experience with frame modification, so i dont quite know what im doing with that, that is why im hesitant to work on the frame, i have always understood if the frame is cracked, (especially on a flexing vehicle) you dont weld it, because the welds wont hold... that is the only...

the only real junk yard i know around here is that one guy one guy in hubert with the offroad shop/4x4 yard, but he hasnt been very friendly (or cheap for that matter) when i tried to get parts from him in the past, other than that i dont know of any place around here. also, this ch frame has...

the cj frame i bought was modified and is very strong, so im not worried about that, but if a yj will fit on a cj, that means that the cj should have no problem fitting onto the rest of the yj?

i have an 89 yj (6cyl 5spd) and i have a pretty decent crack in the drivers side framerail (i have pictures of the framerail http://drag0n.homelinux.net/jeep/ inside.jpg is the view of the inside of the framerail, outside.jpg is from the outside side of the framerail and bottom.jpg is where the...