Recent content by TheGhost45

Sorry not the MTX Jackhammer JH202 it's the JH404

Terry I seen your write up, I am definatley not that handy haha otherwise I would totally go for it, I'm really new to the car audio world, but I know what sounds good and the set up I have planned out I have a feeling is going to sound amazing, the enclosure I was looking at is ported already...

Ok so just got my wrangler all together freshly painted lift installed bigger tires the whole 9 yards pretty much I want to upgrade my sound system now so it sounds a little better I have the subwoofer picked out it's already in an enclosure I've got my amp picked out it's a mtx jackhammer 4...

252000 still going strong.

Doing a 5.2 magnum swap with transmission out of 1997 dodge ram van what else should I pull from the donor vehicle other than the engine transmission wiring harness and ECM ?

My springs perform great, I love my lift I don't see why people call it malljacker when alot of guys use it for their rigs and have awesome.

All stock rear end...with 10" of lift wow. That whole rear end probably had enough tell him to change out the whole rear and put in a dana 44 or ford 8.8 or if he wants to go big off the top a Dana 60. Anything is stronger then stock I think the rear on that is an Amc 20.

Personally I think skyjacker is the best, but most of it is matter of opinion.

I believe I have a 23 spline input shaft because I have a 4.0 auto 3 speed it's the TF999 I was looking around to see if the 5.2 magnum would bolt up to that transmission but could find much so I figure if I have the transmission that comes with the 5.2 which it could be 44RE 46RH 46RE I was...

I'm looking into a 5.2 engine swap and need to know Will a 46RH or 46RE transmission bolt up to a NP231 transfer case?

You could cam it, check out comp cams. You could throw a set of headers on it you could supercharge or turbocharge you can port the heads you can upgrade your ignition system you could get a Jet performance chip although alot of people say they don't work, but some think so I personally think...

31x10.50R15 Dick Cepek Crushers!

Ok, so the transmission from that truck wouldn't work with my jeep? I know that the truck wouldnt have a transfer case, so I could buy the adapter for that but for the transmission, is it going to make a difference with it being 2wd and the jeep 4?

Truck is a 2 wheel drive can this still work?

Weird :S never heard of that before and it's no problem man.