Search results

Hi Guys, Just rebuilt my engine on a 1999 Jeep Cherokee XJ 4.0. Does anybody know of a good procedure on how to install the distributor on the engine. I know that the engine has to be set for the #1 cylinder at TDC on the compression stroke. Any recommendations where the rotor should be...

Hi Guys, I have a 1995 Jeep Wrangler 2.5l and I am having trouble with my 4x4... When I engage the 4x4, the front wheels don't engage. When I look under the car, I can see the front drive shaft turning, but the front wheels aren't engaged. One thing I also noticed is that the 4x4 indicator...

Selling my 1995 YJ Wrangler 2.5L 5 Speed 4WD. Here is what I recently done to the truck. · Completely rebuilt engine · New serpertine belt · Transmission rebuilt two years ago with new clutch · New front and rear transmission and transfer case shaft...

Hey Guys, Thinking about selling my 1995 YJ Wrangler 2.5L 5 Speed 4WD. Just wondering what you think the truck might be worth. Here is what I recently put into the truck within the past few months. · Completely rebuilt engine · Transmission rebuilt two years ago with new...

Hey Guys, Just replaced my master clutch cylinder on my 95 YJ 2.5L because it was shot. The clutch pedal is very soft. There is virtually no pressure on it when pushing down on it. I topped off the fluid and I was going to bleed the slave cylinder. However when I try to bleed the system and...

Hi Everyone, Need some help with an oil leak. I had oil dripping off of the inspection plate for the transmission. After removing the inspection plate, I saw oil all over the inside of the bell housing. After I removed the transmission, I was questioning myself if the oil was coming...

Hi Guys, Any advice on how to install a distributor on a 1995 2.5 yj on a disturbed engine? I want to make sure it is installed correctly so it starts! Thanks

Hello, Just finishing up a rebuild on a 1995 YJ 2.5l. I am having trouble mounting the power steering bracket back up. I know the front two bolts bolt up the water pump but where the back bolt mount to? Does it mount to the motor mount with the stud on the top? For the life of me, I...

Hi Guys, Just finished a complete rebuild on a 1995 YJ 2.5l. I did a compression check right after I installed the engine into the truck. No intake/exhaust manifolds were installed during the compression test, The compression test was completed dry. Here are the numbers... #1 - 150 psi #2...

Hey Guys, Just replaced the timing chain on a 1995 YJ 2.5l but I forgot to put the timing chain snubber in. The million dollar question is that is the timing chain necessary and should I open the engine up and install the snubber? Thanks, Pat

Hey Guys, Any idea what this part is for? Doing a rebuild on a 1995 YJ 2.5l Many Thanks, Pat

Hello, Any recommendations on where to purchase engine parts for a 2.5 rebuild? Should I get OEM? Thanks

Hello, In the process of rebuilding my 2.5L with 234,000 miles. I have a valve grinder at work. Does anyone know the valve/seat angles on the intake and exhaust valves? Thanks