Search results

So I had a backfiring issue after replacing my Carter carb to a Weber carb, I tried everything to a point where I even replaced my EGR valve. Then I undid my PCV valve and no more back firing. My question is I put a Small filter on the other side of the PCV valve and that seems to work, is my...

Hey guys, have a problem. I have some back firing so I'm going through my tuning stages. After doing my timing which is very hard to do when there are no lines to set my timing with, it won't start, nothing, like the battery is totally dead yet I have a full battery. Did I do something by...

An other question, just installed a new Weber carburetor, idles beautiful at 800 rpm. When I drive it cold it back fires every time I push down the clutch. If I let it warm up it back fires when I hit the gas when my clutch is down to get my rpm back down to 800 rpm. When it's hot the rpm...

Just installed a new Weber, starts fine but after 30 seconds it just dies. Rpm still running a little high. I had to cap off a lot of vacuum lines due to no place to plug in. I have a fuel regulator set at 30. Any suggestions.

Hi guys I have a quick question, I just ordered a new Weber carburetor 32 36 for my cj7 258 4.2L. And I keep hearing this carb only uses one vacuum line, what do I do with all the other lines, is this going to be an issue. I'm just a diy'r and carb's and vacuum lines are my nemesis. Any quick...

K I have a strange one, my cj wants to start without the keys in the ignition. It is stored right now for the winter and I just wanted to start it to get the fluids moving, it would not start for me so I tried a number of times the all of a sudden it would continue to start without me turning...

Ok DIYers, here is a challenge. I have a CJ7 with gauge issues, both my temp and gas gauge are not working, one issue I have is I have lost the jumper/regulator strap and replaced it with regular wire. I have tried to replace the strap but nobody seems to sell them anymore. My next step is...

Replaced my thermostat yesterday, now I have a leak. I pulled it back off and noticed that I do not have a even indentation in the gasket. I dried out the gasket since it was new and tomorrow I will put on some gasket sealer. Is there anything else I should do.

Hi all, new to this forum and hope someone will be able to help. I installed a Rough Country 2 1/2 " lift kit with 200 psi shocks, my ride is a 100% worse now then with my old worn out springs and shocks. The ride is so hard now, my wife won't even ride with me. Is there a way to soften her up a...