Recent content by BDurrant

Red hose with the T from the dana 30 front end. Where does the vaccum source come from? I know it's the carb but where on the carb? and how should it be routed through the storage cannister?

Thank you for the info. I don't have a copy of the vac diagram under my hood, go figure. You say that the line goes to the storage canister then behind the valve cover to a T, one side ends up at the Manifold Vac port above the EGR but where does the other side of the T go. Thanx again

OK I did the Nutter Bypass and while I was eliminating the miles of wire and vac hose I found the RED vac hose from the front axle and it was just plugged. I was given the 1989 yj recently and I haven't ever driven in 4wd. my question is, where should the vac for this line come from? I have many...

I lived in and Jeeped Utah for 50 yrs. moved to Maryland for the work thing. I grew up in A F and moved to Provo at about 31. Owned 3 different Jeeps while in Utah and spent tons of time in Moab and in the Wasatch. I miss the jeeping there. I now have a 1989 wrangler that my Boss gave me so I'm...

My best bit of advice is that you throw the wrenches in the air, do a quick 180 and run, run, run. This jeep life is not the way to go. UNLESS of course, you enjoy hours of working on it, spending your life savings on it, begging the wife for time and money for it. And the thrill that can only...

McMud: I just completed the 'Nutter" and ran my vac according to the schemmmatic in question. it's warm here and I don't know if i will have problems when it cools down. I researched the nutter for quite some time before I did it and found tons of schm that completely support the diagram you...

I just "Nuttered" my 89. Runs like my old 81."before vaccum spaghetti" no hesitation just power. I did have to remove and clean the venturis in that Crap Carb for a smoothe, low idle. That takes about 30 min.