Recent content by DerekC

  1. D

    Excellent CJ7

    off da market, got the money I needed :D
  2. D

    Excellent CJ7

    Jeep is in Dallas will ship ..you pay. Pics to come soon
  3. D

    Excellent CJ7

    Must sell Must sell must sell must sell... Moving and have to raise cash to cover expenses 1980 CJ7 Red paint is 2 years old 1 month old Bestop Super top Black -all new hardware and new matching soft doors Brand new black rock crawlers 15x8 with 2.75 backspacing. on New 32.11.5x15 buckshot...
  4. D

    gas prices

    RE: TFI upgrade Q Acetone in your fuel ...I am testing this after reading NUmerous articles. 15-35 % increase in mileage
  5. D

    TFI upgrade Q's

    hmmm, lotta questions lemme see if I can help. 1)I bumped timing 1-2 degrees worked fine for me. 2) I ran pig-tails to the old wires that attached to coil, has worked fine, whether they are getting 1 or 12 is a moot point to me since it works, but to find out I will read them with my mutimeter...
  6. D

    Axle Questions

    RE: Re: RE: Stuck line truck SenorCole, As you know I have the same 3.07 in my CJ and I run 32x11.5x15s on my rig. No the stump pulling torque is not there as it would be with 4.56s ect, but I do fine when I go out. When my speedo says 65 mph I am turning about 2600-2700 rpm, I do have an auto...
  7. D

    4 High no workie :(

    Did 4" suspension lift. Yeah wife toosed some carb linkage, rectified that with weber swap. I am going to bring it to work and put it on the lift to do some routine stuff, will drop skid plate and see if linkage is outa whack. Could T-Case lowering kit mess with linkage for t case? I added one...
  8. D

    Right stuff for right person

    RE: VERY VERY Clean Bikini, windjammer, tonnau cover-------------------SOLD :) Motorcraft 2100----------------------------------------SOLD :)
  9. D

    VERY VERY Clean

    4 High no workie :( Sold :)
  10. D

    4 High no workie :(

    RE: Will CJ 1/2 doors fit a YJ? Since my lift was installed( do not see how that affects it) my 4 high is inop. I have a TF999 transmission mated to the factory Dana 300. 4 low is all there and works absolutely fine?????? :?: -D-
  11. D

    Right stuff for right person

    Re: RE: Re: RE: Re: RE: Politics, religion, and her yes I do. Have it and all I mentioned that comes with it.Shipped to you $75 -D-
  12. D

    Chevy tie rod w/heim joints

    I have seen several vehicles with a shortened chevy tierod running heim joints instead of ball joints at the ends, read somewhere that they run about $100...would like to have one as I boogered up my tie rod on a stump lat night :( -D-
  13. D

    VERY VERY Clean

    RE: carb problem please help Have VERY VERY Clean factory CJ wheels for you resto guys.ALL 5...15x7 Chrome wagon wheels. Obviously 5x5 1/2 bolt pattern. came off my 80 CJ7..make an offer. Will ship in boxes that my new rock crawlers came in :) ) -Derek dereklcanterbury@hotmail.com...
  14. D

    Farewell To the Pope

    I agree with the others, I am not catholic but as he was in his unfortunate state before death, my family prayed for him as a MAN, just a man, that his suffering would be short, and those that cared for him would be comforted, I believe those prayers were answered. -D- Be grateful in your...
  15. D

    pass, pass, pass,pass... fail!!

    Nox is a result of EGR system not funtioning properly, CAN sometimes be caused by fauly cat converter...I am a state inspector and Toy tech in Dallas, we use them same tests as California in Dallas/Ft.Worth metro area. Although in Texas 24 years and older are smog exempt, just a safety...
Back
Top