Recent content by Mhulderman

  1. Mhulderman

    Vacuum switch

    the lines look good..is there a way to test the switch???
  2. Mhulderman

    Vacuum switch

    Does anyone know where the vac switch for the 4x4 drive is on a 91 jeep Cherokee??
  3. Mhulderman

    Fuel filter

    Does anyone know where the fuel filter is on a 99 Cherokee sport??
  4. Mhulderman

    Overheating

    We have replaced the radiator,water pump,thermostat and it's still overheating? Any ideas?
  5. Mhulderman

    Fuel filter

    I'm tryin to find my fuel filter on my 99 jeep Cherokee when I ran across this.....What is it???
  6. Mhulderman

    overheating

    I put a 165 in it
  7. Mhulderman

    overheating

    I have a new themostat..water pump..hoses and I just put a new from junkyard radiator in my jeep..but it still is overheating??..I'm not loosing any water but it will warm up...cool down...the warm up then slowly get hot...any clue???
  8. Mhulderman

    squealing

    It has the serpintine belt
  9. Mhulderman

    squealing

    I have a 91 jeep cherokee with the inline 6. When I turn on my heater the engine/belt/something!..makes this ungodly squealing noise. My alternaoter/ battery gauge also goes down consiberably??....Any Ideas on what the problem is????
  10. Mhulderman

    Serpentine belt

    My idler is under the power steering pump on the other side of the engine coated to your pix
  11. Mhulderman

    Serpentine belt

    Yes it is on the drivers side under the power steering pump
  12. Mhulderman

    Serpentine belt

    My idler is on the other side of the block???
  13. Mhulderman

    Serpentine belt

    My 99 jeep doesnt have the sticker showing how my belt should be in dies anyone have a diagram?? The one in my Haynes manual doesn't match my jeep the idler pulley is on the other side
  14. Mhulderman

    Vaccum canister

    I have a 91 jeep Cherokee and my 4x4 drive is currently not working...I crawled under her to check the vacuum actuator canister and realized it was loose ... Should it be loose or have a tight fit to the axle?????
Back
Top