Well I believe I nailed it.
Pulled cap and rotor. Pickup looked terrible.
I put pickup,rotor, cap, wires, and plugs in it just over 2 years ago and you wouldnt even know it.
I cleaned the rotor and cap, replaced the pickup.
Found something else too. A few years ago I replaced the oil pressure...
lol this jeep has had its share of problems. I will say that Chryslers do not like aftermarket parts at all.
I ordered a new pickup coil/cam sensor. to install tomorrow. The last time I replaced the pickup was 2012 and it was for the same reason. It sucks when things are random because you...
I drove the jeep today and of course it did it. I was going down the road and it was like someone shut the key off. I tried several times to get it to restart while coasting but it would only chug and stall.
Once I finally rolled to a stop and got it to the side of the road it fired right back...
you are lucky. most dont like to, and if they do they wont warranty as good. I only stick with timken or skf. Usually skf is a little cheaper than timken though
Update 7/1/14.
I ran the engine and started from the pcm connectors and followed both the CPS and the pickup, problem would not occur. I am thinking there is a bad wire somewhere in the loom to the pickup. Maybe once it heats up it breaks connection. I ran it and drove it today, code would not...
Hi all. Well the jeep was running good for a little while.
To refresh all. It is a 1996 jeep cherokee, 4x2 4.0l6
It throws a code P0340. Cam sensor ckt a, Bank 1 or single sensor.
My research showed to change the crank sensor. So I did last week. I found the wires at the sensor itself were bare...
Ok guys wonderful news.
o2 sensor replaced, light went out same day, hasnt come back on. runs good without spell, passed NYSI yesterday.
So there was 2 problems, 1 being the pcm, once I swapped out the pcm and the light came on for the o2 sensor I knew where to go with it.
I will say I am not...
no problem. I speak from experience. I have 3 v8s amd I drive them all hard. one seeps a little oil and when I drive it I can smell it sometimes. In order to fix it though the engine has to be pulled so I always just dealt with it
I know this may sounds stupid but I have to ask. according to the vin is it a 4x4? What makes you say it is a full time 4wd? See if the transfer case was removed the rear driveshaft would have been changed also because the transfer case bolts to the rear of the trans and the rear shaft goes to...
wait what? you are saying you dont have the transfer case or front shaft?
That would mean that someone changed the rear driveshaft and possibly the trans. Please give some more info
that is interesting. do you have an oil leak? If you did you may not smell it under normal conditions but under load it creates more heat and tends to burn off and smell more.
Welcome to Jeepz forum
Ouch I have gone through this before, Is there any kind of warranty on the seats? Unfortunately I cannot think of any way to ensure safely installment of latches. 94-96 was a common year range for the change from front button release to the top red release style latches so therefore the...