Search results

Even though a stock engine doesn't produce a lot of power to require a performance clutch, trying to turn large tires is just as hard on it. Especially when off road climbing rocks ect. I replaced my clutch a little while back and did a lot of research into it before buying. After a lot of...

Hey. I've seen a kit advertised at our local shop that ties in a stock rollbar to the frame. It extends the stock rollbar through the floorboards where it is then welded to the frame. Anyone ever used one of these or heard anything good/bad about them? I've heard stories of the stock rollbar...

Never mind. Got one.

I tried pulling an old 21 foot fiberglass boat with a big old heavy trailer a couple of blocks from one friends house to anothers with my 93 YJ. Pulling it wasn't a problem but when it came to stopping, it just wouldn't stop. The weight of the boat just kept pushing it. We weren't near any busy...

Have you checked the transmission fluid?

I have a 2 1/2" lift on my YJ with the t-case drop and it seems to be at it's limit. Without the drop I'm sure the driveshaft would pull right out at full articulation. It'll also help with driveline vibrations. If you have the drop kit then I would go ahead and do it since it's a very simple...

I was in at his shop last weekend. He told me he didn't have any used female ends. Tried to sell me on the whole seatbelt set.

I had a problem with mine in my 93. The circuit board was blown. If you do find a plug, the ones from the 93's are different than that of the 94's and up. Don't know what's wrong with yours but if it's just the lighting like mine you can purchase glow guages. They are white overlays with a wire...

Mine were a real pain to get out. I ended up taking out all the screws under the dash (along the front) so I could pull the it out a couple of inches. It was enough to get some tools back there. If you find that too hard, you could remove the whole dash which is very easy but time consuming...

GO VANCOUVER!!!!!!!..........Ooops. Mabye next year.

Mabye I can get my wife to do a bigger lift and a motor swap on mine........ya right!......she hates the jeep.

What kind of top? My Bestop soft top just unbuttons from the frame.

DO NOT break off your bodymount bolts with a breaker bar. I broke one of mine off and the threaded half was stuck inside the body (rear passenger side corner). Had to get a torch and cut the mount out......pain in the a$$! If they seem stuck at all, spray all the body mounts first with something...

Hey. I've got a new dent in my driveshaft that's causing major vibrations. It's unrepairable and cannot be balanced. I called around about getting a used one to replace temporarily until I get my SYE kit out of storage and get a CV shaft made up. Won't be able to get at the SYE kit for at least...

Not sure if Chrystler's Tire Pressure Monitoring System (TPMS) works the same as other manufacturers. I work in a wheel manufacturing plant and we make the wheels that use this system. The wheel has a specially drilled valve hole to accomidate a special valve stem. If you take the tire off the...

I got one for my YJ made by a local company here in Vancouver. They're called Serious Metal. I've bashed this thing off rocks and beaten it to hell with no problems. The only improvements I can see that they need to make are to the latch for the swingout carrier....it rattles a little too much...

Come to Vancouver, Canada and I'll show you lots of places.

Sure hope that war moves over here to Vancouver.

Never looked into the altenator on my 4.0L. Do they have the same one and if so will this swap work on a 4.0L?

Your best bet would be to take it into a shop and have them test both your battery and your alternator. A lot of places will test them for free if you buy either the battery or alternator from them.