Search results

The gas gauge quit working so I bought a new one from Quadratech, make that the sending unit-float assembly. Anyway before I put the gas tank back in I hooked back up to fuel gauge. And what do you know, didnt register anything. I had a gallon of gas or so. So I pulled sending unit out...

Will a 76 cj5 body tub fit on my 75 cj5 frame? I know the windshield frames are different, but if I use my 75 frame-windshield, will everything else work for me. Will this also work with my new softop? I found this body tub to rebuild and I am hoping to pull this off without having to get a...

Hey guys I have access to a 76 wagoneer with ps power disk brakes and 360 motor. Can I swap these axles to my 75 cj5? It has disk brakes so I am just wondering if it will work. Same with the power steering, steering column, and anything someone else thinks that I should do, etc. I really...

It's been awhile since I posted last. Too much has been done to the Jeep, more than I wanted! The latest problem with the Jeep is the suspension. Rides like a tank. Crawled up the rear, and the shackle is horizontal. That'll jack things up a bit. I don't know much about what has been done. It...

New problem same Jeep-75 CJ5. I am running 220 on temp gauge running a 304. Radiator is new, heater core new, hoses new, and a motorad failsafe thermastat.. I put the thermastat in boiling water to check it-works. Flushed cooling system, and back flushed-good. Bottom radiator hose is not...

I am in the process of putting upper and lower ball joints on my wifes jeep. 75 cj5. As I was pressing out the upper ball joint, the bottom blew out! So basically the O.D. of the ball joint is still in the steering knuckle, while the ball and socket sets on the bench! Any ideas on how...

Hey guys, I got a 75 cj5. What or where does the spring on the clutch pedal hook to? I am talking about the long spring that is attached at the top of clutch arm under the dash-inside the jeep-and hangs down. I don't see anywhere to hook on -I assume the floor someplace? Thanks!

I am trying to hook up my heater core. The fittings are 1/2" for the core and 3/4" to engine and water pump. Did Jeep use connectors to reduce down to fit? I don't have anything to go by. Wasn't hooked up when I got it. Thanks!

I have a 75 cj5, what columns can I get for it. I know ididit and flaming river sell them. I would like to spend less money than these go for. Also any idea what would need to be done to make work with factory box to column?

New to the forum, and the Jeep world! My wife has wanted a jeep forever. I found this little money pit at a truck dealership. The bodywork had been done, but not neccessarily that well. Lots of bondo and poor repair techniques. Right away, gas tank began leaking. Brakes lights stopped...