chevey 350 for sale

[slo-wrench44]

ok here goes. i rebuilt this 350 and never ran it more than 5 hours.it has new crank, crank bearings. connecting rod bearings lifters and valve seals. and new timeing chain. i didnot replace the cam or pistons and connecting rods. it does have new rings though. its a late 60's block with newer heads from an 82 camaro. its been on an engine stand and needs to have the heads bolted back on and needs head gaskets and a carb and intake and distributer.. took them off to show the condition of the bore to a buyer but it fell through . i am asking 200 as is and i will trade for a slip yolk elim kit for my 88 yj . new full trade .. used trade plus $50 i live in upstate ny so i dont plan on shiping it it will cost an arm and a leg. anyone interested write back and i will go out and take pic and e-mail to you.
later
O'Lee

 

[jeepin916]

RE: Widetrack 30 and 20

hey im lookin for a 350 block 2 piece rear main seal and a 4 bolt main if u know of any also where in upstate NY are you? is your block a 4 bolt main? can u get the casting number off the block for me? thanks Ken

 

[slo-wrench44]

Re: RE: Re: RE: More evidence, that I have too much time on

sorry its a two bolt main. doesnt matter unless you plan on raceing it though. i could get the casting # if i knew where to look . so if ya know let me know and i will find it. i think itried one time and didnt find it. i live in montgomery county not far from fonda.

 

[jeepin916]

oh 2 bolt? sorry i actually am looking ot race it and spray it with at least a 200 shot of NOS, thanks any way