it seems that my rockers are not getting oil after start up...the rear ones are but the ones for cylinders one and two seem to take awhile...they also sound like they are chattering running down the road or sitting still...they were all torqued down with the valves closed...and to 18 pounds each...according to my haynes...actually i did 20 pound because my torgue wrench starts at 20...
it runs fine other than that...just a concern...
the oil pressure sits at about 30lbs...at speeds it picks up...but it hops around...i think maybe my electrical problem is gettin into my gause as well...
my temp gause reads off scale hot at all times when electricity is aplied...and the ful gauge reads off scale full...but it has done that since i bought it...at half tank it reads correctly so i think maybethe rheostat in the tank may have a dead spot?
it runs fine other than that...just a concern...
the oil pressure sits at about 30lbs...at speeds it picks up...but it hops around...i think maybe my electrical problem is gettin into my gause as well...
my temp gause reads off scale hot at all times when electricity is aplied...and the ful gauge reads off scale full...but it has done that since i bought it...at half tank it reads correctly so i think maybethe rheostat in the tank may have a dead spot?