I have a 94 Grand C. 4L. The outer crank pulley has separated from the inner pulley.
Has this happened to anyone else? There is alittle room to work, I was wondering if I can remove and install a new pulley without pulling the radiator. Thanks for any help.
I have a 93 Grand C.4.0L. I need to replace the o-ring on the oil filter housing. To remove the bolt thru the housing I need a hex bit, it looks to be about 3/4 inch. Does anyone know the exact size of the bit needed. Thanks.
I am pulling the transmission on my 93, it however takes the 42RE transmission. Hard to come by in good condition, in my area anyway. I am told you can't interchange it with the AW4. Can anyone tell me the difference between them? Thanks.
I'm pulling the transmission on a 93 grand cherokee 4.0. I was thinking I could pull the transmission without removing the exhaust. Now I can't see how I can remove the dip stick bolt without getting the pipe out of there. Any advice on removing the top bell housing bolts. Thanks for any help.:cry:
I have a 93 Grand cherokee 4.0. When dropping the transmission do I have to remove the exhaust. Its tight but it appears that if I can pull the transmission far einough back it will clear. Thanks for any help.
I have a 2001 cherokee sport with a broken u-joint passenger side front.
I have changed the half axels on my 93 jeep which has a CV joint, this is different and only has the open u-joint visible. Question is, can I pull this axel and replace the u-joint or should I replace the whole axel? Some...
I have a 1993 Grand cherokee. I am removing the transfer case. Can someone tell me the best way to remove the top bolt where transfer case attaches to transmission, it's a very tight fit and I am wondering how the pros do it. Thanks.