i gotta 96 grand cherokee 4.0 and im havin problems it keeps wantin too run hot if you start it and not drive it itll hit 210 and never gett any hotter and the thermostat dont feel like it ever opens but you can go drive it and itll run the 2nd and 3rd mark past 210 mark iv putt 2 water pump in...
Will it hurt anythang if I remove the front drive shaft in my 96 grand Cherokee for better mpg its gotta 4.0 auto trans and full time 4x4 transfer case
my 92 cherokee (stock 4.0) wont sstart all it does is clicks i have tried jumpin it and it will sometimes turn bout halfway over then just starts clickin it did this the other day and i wiggled the jumper cables aand it started but ran really rough for bout 30 sec then fine i went too start it...
Well guys I thank I gotter figured out I had it ggrounded into the factory harness but the wire had one of those male conector ends on it I cut it off and it aint doin it now
I got it wired positive to the fuse box and ground threw factory harness the antena never has been hooked up it was wrecked and they cut the wire off the fendwr and hooked speaker wire too the antena cable
so iv been thankin bout weldin my front axle its on a 92 cherokee stock fronnt axle too make it possi would this have an effect on daily drivin on the road? and would it hurt if i did the rear as welll?
my 85 chevy pick up had flowmaster 40 on it when i bought it and its straight pipe off headers and you cant beat it my buddy had a 96 with thrush glass packs on it and it was pretty loud too