Search results

well, I checked all my fusible links and they were all fine. Probably is going to be the Body Control Module, behind the inside fuse box on a liberty and is going to be a mutha.... to replace. I will let you know.

Anybody know if these are all controlled by one fuse? wtf? Any help is greatly appreciated.

Still after all this while my heater wont work so i went to this link - | Repair Guides | Control Panel | A/c & Heater Control Calibration | AutoZone.com. Has anybody on this board had this problem and this fixed it? I have tried and done most everything. If so this sequence doesnt work for me...

Looks like that is exactly what happened.

Well, I dropped both wheels off the jeep and found that on the front left, one of the studs broke off and 3 of the other 4 were very loose. I torqued them down. And now tho my speedo quit working and my engine light is on. WTF.

I inspected the tire and parts for visible wear and tear. They seem ok. I am going to change the front brake shoes and that may fix the problem. Thank for your comment. I do appreciate all help because I am far from being a certified mechanic. Peace.

I was out on a drive with my wife last night and about 40 miles into it the front right side of my jeep started vibrating pretty bad, the noise was a loud thump thump with every tire rotation. When accelerating and braking the problem would not be as intense. I know I need to replace the front...

very nice. i want one just like it.

Me and my sweethearts at Elkhorn Mt 11/14/09

i appreciate your advice. i will perform these this evening after work. also, i meant the outside temp as under 40 degree's. lol. i hope my mech took the right steps to ensure the thermostat and mix is correct. i will get back on this with you when i check it out. thanks again.

hey all. earlier this year my wife hit a deer, didn't do any damage except broke the radiator. took it to a local radiator shop. they replaced the broken with new. they didn't put in a new thermostat. this past week i had a new thermostat installed at a different shop. meanwhile between...

i agree with this post. i am a painter, and if you use rattle cans your consistency with not be near anything you want. and also you preparation is the most important steps you will make. maybe read up, get some friendly help and also have fun.

welcome. cool rides.

Stumbled in the other day. Probably how most here do. 8)Good to see other folks who still do it outside. Looking forward to the fun.