wires

Hello Jeepsters, Just wanted to post my current issues and see if any might have any tips or experience with the following issues that I'm experiencing, also wanted to contribute an issue that I resolved recently in the hopes that it might help someone else. Issue 1: AC Blower not...

I have a 2010 jeep commander giving code P0335!!! NOT P0355 I entered wrong code when typing last night!!! I have replaced the ckp sensor with 2 different sensors and get same issue. On the dash it has the red lightning bolt flashing and the esp and bsm lights on. When cranking it takes a good...

Hello All I am trying to figure out what wire is what. I need to install a Road master Brake Pro 9300 Proportional Towed Car Brake Unit in to my 1993 Jeep Wrangler 2.5 5 speed I have attached the type of connector I need to tap into. This photo is the switch side, the plug/harness side has 5...

Hello, I need some help I needed to change out my old spark plugs and wires yesterday, but after I swapped them out with new parts the engine refuses to turn over. I have quadruple checked the firing order (153624 going CW) and have put in and taken out the plugs and wires twice, even putting...

I have a 97 Grand Cherokee Laredo 4.0. I'm having a crank but no start issue here. Now i have replaced the PCM, distributor with plugs and wires, crank sensor and a battery but nothing. Does anyone have any advice on this?

I have a 2006 Jeep Liberty, 3.6L. I have attached a hitch and am now trying to figure out the wiring. I have looked online and know how to connect the wiring behind the rear lights etc but I was wondering how to tell if my Liberty already has the wiring in place. There are wires under the...