tracbar relocation

[Snitty]

who's got a picture of a lower relocation for the front tracbar on a YJ? i need to figure something out here.. something that works, somethign that works well... i really need to hook it up... even a 2 block drive to work seems near deadly

 

[TwistedCU]

Snitty it is just a bar with 2 holes in it. look closely, it's the only pic I could find. If I remember correctly it had a bend at the bottom that held it from moving laterally. It was also pretty thik steel.

I know, not much to go on, but it's all I got:

 

[Joopin]

Snitty, its the silver piece in the middle-right next to the nut and bolt... really easy to make. Mine kept shifting as soon as I turned the wheel, so to get the play out of the relocation mount, I welded it to the axle instead of bolting it.

Joop

 

[Bounty__Hunter]

Rough Country makes the best track bar bracket I've seen, for a YJ. It has a gusset that bolts further down the axletube, to keep the bracket from shifting. It's about $40 if you contact them direct.

 

[LVRockCrawler]

my hellcreek lift had rough country hardware and the relocation bracket mounts flush in with the gusset for the vacuum switch on the front axle - you have to drill a hole to hold it but it was much stouter than the one that came w/the pro comp kit i put on the old 91 sahara...

 

[Snitty]

yeah i was thinking i'd use some plate to raise the bar end... but couldn't really figure out how to keep it from pivoting since it would only be two points...

 

[currupt4130]

ive got one if you want it snitty, it came with my soa kit and i cant use it cuz i went too big, just pay the shipping and its yours.
i dont run my track bars at all, all i connect for the daily and interstate drives are the sway bars, i might make something to fix the track bar deal but i really dont care, i dont notice that much of a difference

 

[Snitty]

i'd say send it... but i'm workin on fixing it when i wake up