Recent content by jeremyn

1064225 How about 2 complete rear taillight assemblies(need drivers and passengers)? Since they are small will you ship? Thanks jn78cj@cs.com[addsig]

1040510 Depending on your cash flow, I would leave most of your hard parts as they are. I was given the advice to run with what you have until you learn what you really need. I have an 83 CJ7 with 33's and 3in lift - really not enough if flexed hard. The TJ's as I am told are very capable in...

1040630 The real issue with your CJ is not the drivetrain but the weight and brakes. Those Cherokees with the 4.0 can safely tow more because they have a braking system and vehicle weight which can help keep them out of the ditches. With a trailer that's too heavy for the CJ, it would be very...

1041031 The output of the Dana 300 is centered, so any axle with the diff at center should work fine. The bulk of the T-case is hanging on the passenger side of the vehicle in a stock jeep. The skid plate has a bulged section to protect the part hanging down. I think that I saw somewhere that...

1041291 Hope this post isn't too late. I had been having the same problem on my '83 Cj7 after replacement of the bellhousing. I thought that it needed to be shimmed up somewhere, but You might want to check the grounding of the starter. I dropped a separate ground wire to the starter and it has...

1041292 I have never been to Seattle but I am sure you could find a CJ/YJ in your price range, but what about the XJ? I know it might be blasphemous to the open top crowd, but over here in the southeastern part of the country, you can find lots of XJ's with decent mileage and they are many...

1041478 Sounds like a good idea to me. I am located in central Kentucky. [addsig]

1040249 I don't remember if they have sets for early wranglers, but try www.rockhard4X4parts.com. I was there checking out the sets they have for CJ's and they look fairly stout. [addsig]

1054433 'fraid so. I try to keep tabs on the posts here and I have been going back through several months worth to look at lift recommendations. I see the Pro Comp's, Rubicon Express most often and maybe an OME or Rough Country. How about some of the other folks out there - anybody running...

1059398 Anybody know what I am looking for? I want to take an air conditioner pump and hook it up to my 258 I6 as an air pump for tires/tools, etc. I think the name is York, but are there other pumps which would work as well? Can I steal one from Ford/Chevy and get brackets made to work? Did...

1064228 OK, maybe I just cannot see this right in my mind. Or maybe I am right. Ther was an article about someone using a 3.5" lift from a YJ in a CJ. I thought this sounded really cool. The YJ has a wider front spring to hopefully improve handling and the lift is a little shorter to keep...

1040245 I just got an 83 CJ7 with 258. I don't know a whole lot about the history, but it has an Offenhauser intake with Holley 4 bbl on top. I was told(unconfirmed) that it has some type of performance cam also. The starter(new) can turn the engine over a few times then the engine seems to...