Search results

Hi everyone at Jeepz. Has anyone ever seen this before. The bearing split and is stuck in the 44 housing. How do you get it out. Any ideas appreciated. Thanx

Has anyone had any experience with air shocks on a TJ with coil springs. I use my TJ mostly for hill climbing and rock crawling where limiting up travel may be beneficial without sacrificing droop and was thinking air shocks may do the trick.

Just Got back from a Jeep Jamboree and called Rock Krawler to replace a tie rod from their xfactor steering kit that was bent the first time I used it. The stock tie rod lasted through 15 Jamborees. Of course they wont cover it. They said if you bang the tie rod into a rock its not covered. I...

I am finally getting to go wheelin in Moab. I had booked a ski vacation in Utah for Easter but my Wife hurt here knee and she cant ski. I mentioned that we should scrap Skiing and think Jeepin. The next day she calls me and says she rented a Jeep from cliffhanger and were going. I have been...

Any one ever use these fuel injectors in there tj ??? I was thinking about getting a set and trying them out.

Anyone going to the Vermont Jamboree.

http://4wheeldrive.about.com/ Check this out.

I was on the Jeep Jamboree USA website the other day and they mentioned that paragon has sold thier land. I just looked again and dont see that message again. Anyone know whats going on over at paragon.

Staun's Managing Director calls its customers Idiots From: "Harry Lewellyn" <Harry@staunproducts.com> To: <grandbrass@hotmail.com> CC: <lee@staunproducts.com> Subject: RE: No luck installing your product. Date: Mon, 18 Sep 2006 09:13:12 -0700 Dear Frustrated, We are dissappointed that you...

I just spent 3-hours trying to install a staun beadlock. After much frustration I ripped it out and put it back in the box. I give up. There going back for return. What a piece of crap. The instructions have three pages of what could go wrong when installing them. Hand that to a tire installer...

I just got thru the lift on the 2004' rubi. Anyone need the coil springs before I get rid if them. Let me know i will hold them for a week or so. You can email me at grandbrass@hotmail.com if you want.

I am installing a 4" short arm in my rubi and have been havin a ***** at it for two days now. First I snapped three of the foru rear shock bolts. That was a picnic to get out. I cany get the pitman arm off. I dont have a torch to heat it up where I am. I snapped the top off of the front shock...

I had a check engine light come on. I read it p0441 and erased it. It comes back in a few days. P0441 (M) Evap Purge Flow Monitor Insufficient or excessive vapor flow detected during evaporative emission system operation. What does that mean. I need a new PVC valve. A new gas cap or what...

I remember reading that the rubicon had a lower skid plate than the tj in past years and now its the same. Does anyone know when they changed the skid. I want to buy the shallower one and use it on my rubi as a belly up to get an extra inch. If any one has a good one let me know.

I have five interco tsl/sx 31x13.50x15 on 10 inch rims. I cant keep air in any of them. I checked them with soapy water and they all leak at the rim. Here in New York all auto service companies are a bunch of ripoffs and jerks that dont know anything and most will turn you away if they see a...

Go to google and type failure and hit I am feeling lucky button.

RE: new front axle I cant believe thier are no grease fittings on a tj drive shaft. None on the shafts and none on the u-joints.

Exhaust Dump Valve Did anyone see the news today about the Jeep that saved a plane in flight?

I have an 04 rubi that I just put a 1" body lift on. The wrangler mt/r tires were 30.7" tall (LT245/75R16/E). I just tried a LT285/75R16/D which is 32.8" tall. This tire is overall 2.1" taller with a radius increase of 1.05" which with all calculations considered should fit and it does. I...

RE: Re: RE: Re: RE: HAS ANYONE NOTICED RUBICON REAR BRAKES D Has anyone replaced thier fuel injectors with the accel ones? Are they any better? Has anyone every replace the pressure regulator with an adjustable one. Will more pressure give better atomization improving hp and gas milage or will...