Search results

Lets talk about safety. Any input is welcome. I have driven some ratty vehicles including my 74 Cj5 that if I pushed the clutch in, the body would lift an inch. If I tried hard enough, I'm sure I could have kicked a whole in the floor. A little wiser now. I'd like to see some setups and hear...

Being my first rebuild, I expected to make some mistakes. The first big one that I noticed was not matching my rod caps with the rods after taking them out of the block. All of them are stamped but three of the rods and caps all have the number "3" stamped on the side. The others are 1,2, and 4...

After taking out my stock harness, I noticed that unless I want to repair many of the wires that I may be better off buying a new set. I've seen this Painless wiring brand on a few websites. Does anyone have experience with them and can anyone tell me the difference between the part # 10106 and...

My brother had his rear drive shaft break in his 93 yj with the 4cyl and 3" lift. We are looking for another one and we noticed that he has a SYE kit on it. Anyone know what drive shaft we'll need or will we have to have one made?

This thread may have been started before but I need some knowledge as to where some parts connect to and what some are. First off is my carter yfa carb. I know one inlet goes to my fuel pump/ filter and not sure about the other. Where does it go? Next, this little valve on the lower driver...

I will try to remember to post a better pic of a clean one tomorrow.

Still finding great little things about this $600 jeep I bought. Tell me what you think about this.

I'm in the slow process of breathing life into this CJ5 I recently got. It sat for far too long so I am having to replace the fuel system and someone broke the ignition out of the steering column trying to steel it before I bought it. I'm almost done with the fuel lines. Id like to see if the...

A guy at work informed me that he has a 48-50 model willys that he would gladly sell to me for a few hundred bucks. Has motor, trans, and most of the body. might even have the data plate. Frame is cracked in the front. Thoughts? (I attempted to add a picture, lets see if it worked)

Anyone out there?