Search results

Check for any corrosion on the battery or electrical system. this has happened to me I thought it was the starter but was just corrosion.

Good morning fellow jeepers I need some help. I have a 92 wrangler 4.0 6 cylinder. My problem is the jeep is not charging the battery. I have put in a new alternator witch has been tested by two different shops and is working. I have a new battery with 12.6 V when the jeep is off. When the...

Went through and checked all the wires connections and grounds now the jeep run fine not sure if that’s what is was but ill have to keep an eye thanks for the help i ll post any more problems thanks again

hey guys i hope some one can help i have a 92 yj 4.0L inline 6 . this is what happend today jeep started up fine so on my alll of a suden the jeep stalled out and would not start let it sit for about an hour the tryed to start it started right up drove it around and out of no where jeep...

whats the best way to get TDC

Hi guys Need some help on how to replace the distributor on my 92 yj 4.0. The problem is I have no spark. Some say pick up coil and others say crankshaft sensor. So I tried to do the pick up coil first and in the proses I broke the distributor and now need to replace it any help would be...

this is the last thing keeping me from puting the jeep on the road .. so i looked there is a linkage rod. so at the end of the rod is that the switch that is bad?

i tested the plugs last night and had 12.5v on the high beam and 0 on the low beam. so i think its the switch just dont know were the switch is. thanks for any help..

sorry its a 92 yj. its not a foot switch.

i have high beam but no low beam head lights. were is the switch? is it in the column or under the dash? thanks ..

Hey guys hers what I did to the old yj just put her back together after a long project. Cut out all the rust and welded in new sheet metal, body work and then paint. Painted por 15 on the under side and the in side of the tub. New exhaust, new radiator, new plug/wires, distributor, alternator...

Thanks for the help. I will give that a shot and let you know how I make out.

Hey guys I was told this site was the best out there so any info on this problem I have would be greatly appreciated.

I have a 92 yj and my rear seat belt is all coiled up in side. how do you free the belt.

I was looking at the same lift now that my tax money’s back. Doe’s the kit come with degree shims for the rear or would you need get them. With the t-case drop do you need them? How big of a drop is it 1'' or more?

So the fuel lines are disconnected on top of the tank right. The reason I want to drop the tank is to clean and paint the skid plate along with the under side of my tub

Hey guys its bin a wile since my last post. Have done a lot of work to my jeep it’s starting to look good .any way here is my question I found the write up on converting the 15 gal. Gas tank to a 20. but i would like to take out the tank completely and in the write up it didn't explain on...

1044523 front passenger side. the jeep is a 92 yj the axle housing hit the shock and put a small dent in the shock should that be replaced[addsig]

1044716 thankes for the help guys i don't know what happend but every thing seams ok now have to keep an eye on it [addsig]

1056661 i have 92 yj 4.0 5 speed . i know the sye and a cv drive is the best way to go but that is down the road i have what ever it takes to do it right thanks for the help[addsig]